Global parameters let you set a value once and have it control dimensions and element properties across a whole Revit project. This guide sums up what Autodesk’s Revit 2027 help says about creating them, the difference between driving and reporting parameters, and the restrictions that trip people up.
What global parameters are
A global parameter belongs to a single project file. Unlike project parameters, it is not assigned to categories. Its value can be a simple number, the result of an equation, or a value read from the model through another global parameter.
According to Autodesk, you can use one to:
- drive the value of a dimension or constraint;
- drive an element instance or type property;
- drive an instance or type project parameter;
- report the value of a dimension so it can be used in the equations of other global parameters.
Typical uses are setbacks, floor-to-floor heights, wall offsets or a standard clearance that must stay consistent everywhere.
Driving vs reporting
This is the key choice. A non-reporting (driving) parameter controls a value: label a dimension with it and Revit locks the dimension and creates a constraint. A reporting parameter does the opposite: it reads the dimension’s current value and creates no constraint, so other formulas can use it.
Rules from the help pages:
- Only one dimension can be labeled with the same reporting parameter.
- Reporting parameters are read only; you cannot edit their value in the Global Parameters dialog.
- You cannot convert a parameter to reporting if it is assigned to more than one dimension or defined by an equation.
Step by step: create and use one
- Create it. Go to Manage tab > Settings panel > Global Parameters, then New Global Parameter. Enter a name, choose the discipline and type, and tick Reporting Parameter only if it should read a value rather than control one.
- Label a dimension. Select the dimension, then on Modify | Dimensions > Label Dimension panel pick an existing parameter from the Label drop-down, or click Create Parameter. From a dimension, the type defaults to Length or Angle and the discipline to Common. All segments of a multi-segment dimension get the same parameter. You can also right-click the dimension and choose Label.
- Link an element property. Select the element, find the instance or type parameter in Properties and click the small button to the right of its value. The Associate Global Parameter dialog lists only non-reporting parameters that match the property’s discipline and type. Pick one and click OK.
- Change values. Click the Global Parameters icon next to a labeled dimension, or open Manage > Global Parameters, and edit the Value or Formula.
Limits to know before you rely on them
- Dimensions labeled with global parameters cannot be included in groups.
- Global parameters cannot be used on arrays in a project, because project arrays cannot be labeled.
- For doors and windows, Sill Height and Head Height are linked, so only one of them can be associated with a global parameter at a time.
Why it matters
Global parameters are one of the simplest ways to keep design rules in the model rather than in someone’s head. Start with a few driving parameters for values that change often in early design, and add reporting parameters only where a formula genuinely needs a measured value. Keep them out of grouped content to avoid surprises.
Source
- Autodesk: About Global Parameters
- Autodesk: Label a Dimension with a Global Parameter
- Autodesk: Defining a Global Parameter as a Reporting Parameter
- Autodesk: Assign a Global Parameter

